INSTALLING THE COOKER HOOD
Fitting the Hood Body
Before starting to �x the hood body, tighten the two screws Vr located on the top of the hood body. Hook the hood body onto the two screws item 12a (not supplied). Fully tighten the screws item 12a. Using a screw driver and spirit level, adjust the screws item Vr until the hood body is level. 12a Vr
Extraction
The cooker hood is more effective when used in the extraction mode (ducted to the outside). Venting kits may be purchased through your retailer or DIY store, and must be ducted to an outside vent of �125mm (5�) or �150mm (6�). The ducting used must be manufactured from �re retardent material conforming to the relevant British Standard or DIN 4102-B1. When the cooker hood is ducted to the outside the charcoal �lter must be removed.
Recirculation
The cooker hood is supplied speci�ed for use in the recirculation mode, with the charcoal �lter �tted. In the recirculation mode contaminated air is passed through the charcoal �lter to be puri�ed and recirculated into the kitchen through the grille outlets on either side of the chimney. To assemble the recirculation duct, place the recirculation outlet connection item 15 into the support item 7.3. Insert the extension ducts item 14.1 into either side of the recirculation outlet item 15 ensuring the connections are vertically and horizontally aligned with the outlets in the chimney. Connect the recirculation oulet item 15 to the outlet on top of the hood body using either a piece of �125mm or �150mm �exible or rigid pipe. Rigid pipe is strongly recommended and should be used where possible as this will ensure the best performance while lowering noise.
